TM 9-2330-381-14
ASSEMBLY
1.
Using semitrailer electrical schematic (figure FO-1) as a guide, reconnect five point-to-point jumper wires (20) and
two diodes (21) to terminal board TB2 (12).
2.
Aline terminal board TB2 (12) and terminal marker strip (19) and install onto gooseneck component assembly (4).
Secure with four screws (17) and locknuts (16).
3.
Aline terminal board TB1 (11) and terminal marker strip (18) and install onto gooseneck component assembly (4).
Secure with four screws (17) and locknuts (16).
4.
Install electrical leads for connectors J1 (9) and J2 (10) through gooseneck component assembly (4).
5.
Aline receptacle cover (15) to connector J1 (9) and gooseneck component assembly (4). Secure with four
capscrews (14) and locknuts (13).
6.
Aline connector J2 (10) to gooseneck component assembly (4). Secure with two capscrews (14) and locknuts
(13).
7.
Using semitrailer electrical schematic (figure FO-1) as a guide, connect electrical leads from connectors J1 (9)
and J2 (10) to terminal boards TB1 (11) and TB2 (12).
WARNING
Soldering fumes are toxic. Avoid breathing these fumes. Work in a well-ventilated
area or injury to personnel may result.
CAUTION
Rosin core solder contains flux which is corrosive. All soldered connections must
be cleaned of all flux residue or damage to equipment may result.
8.
Using semitrailer electrical schematic (figure FO-1) as a guide and soldering gun, solder two wires from connector
J1 (9) to fixed resistors R1 (7) and R3 (8). Clean all flux residue from solder joint.
9.
Using semitrailer electrical schematic (figure FO-1) as a guide and soldering gun, solder two point-to-point jumper
wires from terminal board TB2 (12) to fixed resistors R1 (7) and R3 (8). Clean all flux residue from solder joint.
Secure electrical wires with tiedown straps as required.
10.
Aline and install fixed resistor R1 (7) to gooseneck component assembly (4) and secure with two screws (6) and
locknuts (5).
4-99