TM 9-2330-381-14
4-31.
WIRING HARNESS CLAMP AND GROMMET INSTALLATION (CONT)
Materials
Locknut (6)
Locknut (24)
Locknut (4)
Lockwasher (39)
Lockwasher (2)
Nonmetallic grommet (2)
Nonmetallic grommet (2)
Nonmetallic grommet (1)
Equipment Condition
Gooseneck pneumatic lines removed from gladhands (para. 4-48)
Clearance light access cover removed from deflector (streetside or curbside, as applicable) (para. 4-68)
NOTE
The following procedures identify typical clamp and grommet installations for each
lettered area identified on the locator illustration. At various locations, the clamps
may also secure pneumatic lines or hydraulic lines with the wiring harness bundle.
Perform the following procedures, or any portion of the procedures, as required to
complete the necessary repair.
REMOVAL
1.
Location A: Remove locknut (1) and loop clamp (2) from weld stud. Discard locknut.
2.
Location B: Remove screw (3), nut (4), lockwasher (5), and loop clamp (6) from platform. Discard lockwasher.
3.
Location C: Remove nut (4), lockwasher (5), and loop clamp (6) from weld stud. Discard lockwasher.
4.
Location D: Remove nut (4), lockwasher (5), and loop clamp (7) from weld stud. Discard lockwasher.
5.
Location E: Remove nut (4), lockwasher (5), and loop clamp (8) from weld stud. Discard lockwasher.
6.
Location F: Remove three loop clamps (6), loop clamp (12), and grommet (13) as follows:
a. Disconnect W2 harness leads to clearance and marker lights.
b. Remove nut (4), lockwasher (5), and loop clamp (6) from weld stud. Discard lockwasher.
4-124
