TM 9-2330-381-14
4-31.
WIRING HARNESS CLAMP AND GROMMET INSTALLATION (CONT)
INSTALLATION
1.
Location L: Install loop clamp (22) to gooseneck component assembly (23) and secure with locknut (1).
1.1
Location K: Install mounting plate and grommets as follows:
a. Slide two grommets (20) and grommet (21) over two air lines and W1 harness.
b. Slide grommets up to and install grommets in mounting plate (19), ensuring each grommet is secure to
mounting plate.
c. Install mounting plate (19) onto weld studs and secure with four lockouts (18).
2.
Location J: Install loop clamp (17) to weld stud and secure with locknut (1).
3.
Location H: Install loop clamp (2) to weld stud and secure with lockwasher (5) and nut (4).
4.
Location G: Install loop clamp (16) onto beavertail and secure with screw (15) and locknut (14).
5.
Location F: Install three loop clamps (6), loop clamp (12), and grommet (13) as follows:
a. Install grommet (13) in deflector (10) and pull W2 harness leads through grommet.
b. Position loop clamp (6) at proper mounting hole on deflector (10) and secure with screw (11), lockwasher (5),
nut (4), loop clamp (12), lockwasher (5), and nut (4).
c. Position loop clamp (6) at proper mounting hole on deflector (10) and secure with screw (9), lockwasher (5),
and nut (4).
d. Install loop clamp (6) on weld stud and secure with lockwasher (5) and nut (4).
e. Reconnect W2 harness leads to clearance and marker lights.
f. Install clearance light access cover to deflector (10) per paragraph 4-68.
6.
Location E: Install loop clamp (8) on weld stud and secure with lockwasher (5) and nut (4).
7.
Location D: Install loop clamp (7) on weld stud and secure with lockwasher (5) and nut (4).
8.
Location C: Install loop clamp (6) on weld stud and secure with lockwasher (5) and nut (4).
9.
Location B: Position loop clamp (6) on platform and secure with screw (3), lockwasher (5), and nut (4).
4-128 Change 1
