TM 9-2330-381-14
4-54.
PLATFORM STEERING CYLINDER (CONT)
7.
Using a prybar, install and pry up on sleeve bushing (15) through platform cylinder mount (16) and onto
shouldered pin (21). Continue to pry up on sleeve bushing (15) until flush on platform cylinder mount (16).
8.
Secure shouldered pin (21) to platform cylinder mount (16) by installing clamp (24), lockwasher (23), and screw
(22).
9.
Secure sleeve bushing (15) to shouldered pin (21) by installing self-locking capscrew (13). Using a torque
wrench, torque capscrew (13) to 100 - 110 lb-ft (136 - 149 Nm).
10.
Install self-locking special bolt (19) onto shouldered pin (21). Install lubrication fitting (18) into special bolt (19).
11.
Install seal (11) on sleeve bushing (10). Install seal (11) on shouldered pin (7).
12.
Using a prybar, install and pry up on shouldered pin (7) through steering plate #5 (12) and hydraulic cylinder (1).
Check alinement of flat on shouldered pin (7) and readjust position, as required, until flat is alined with stop tab on
bottom of steering plate #5 (12). Continue to pry up on shouldered pin (21) until pin is flush on platform cylinder
steering plate #5 (12).
13.
Install sleeve bushing (10) over shouldered pin (7) on steering plate #5 (12). Using a prybar, pry down on sleeve
bushing (10) to install bushing through steering plate #5 (12) and onto shouldered pin (7). Continue to pry down
on sleeve bushing until bushing is flush on steering plate #5 (12).
14.
Secure sleeve bushing (10) to shouldered pin (7) by installing self-locking capscrew (8). Using a torque wrench
and a 15/16-inch crows foot adapter, torque capscrew (8) to 100 - 110 lb-ft (136 - 149 Nm).
15.
Apply thread locking compound to threads of special bolt (5). Install special bolt (5) onto shouldered pin (7).
Install lubrication fitting (4) into special bolt (5).
16.
Remove caps/plugs installed and reconnect two hydraulic lines (3) to steering hydraulic cylinder (1).
17.
Perform cylinder stop adjustment, if necessary.
4-272 Change 3