TM 9-2330-381-14
b. If each ball in ball valves does not work properly, refer to disassembly steps and remove valve. Then, aline and
install ball valves (26) until valves work properly.
7.
Install manual control lever (20) onto ball valve (21). Secure manual control lever (20) in place by installing
setscrew (19), washer (18), and capscrew (17).
NOTE
Check position of ball valve by looking through one of the ports on the valve as the
valve is operated.
8.
Operate manual control lever (20) and check that ball in ball valve (21) is moving in proper direction.
a. If ball in ball valve (21) works properly, tighten down nut on bulkhead fitting (27) for ball valves (21).
b. If each ball in ball valves does not work properly, refer to disassembly steps and remove valve. Then, aline and
install ball valves (26) until valves work properly.
9.
Aline manual control lever (15) and clamp bridge (14) between two ball valves (16) and secure in place by
installing two washers (13) and self-locking bolts (12).
NOTE
Check position of each ball valve by looking through one of the ports on the valve
as the valves are operated.
10.
Operate manual control lever (15) and check that ball in each ball valve (16) is moving the same amount and in
the same direction.
a. If each ball in ball valves (16) works properly, tighten down nut on each bulkhead fitting (27) for both ball valves
(16).
b. If each ball in ball valves (16) does not work properly, refer to disassembly steps and remove valve. Then, aline
and install ball valves (16) until valves work properly.
4-415