TM 9-2330-381-14
b. If adjustment is required, loosen jam nut (29) on each end of steering tie rod assembly (11) and rotate steering tie
rod (30) either clockwise to shorten or counterclockwise to lengthen, as necessary.
c. If adjustment was made, tighten jam nut (29) on both ends of steering tie rod assembly (11). Repeat step 12 and
check for full range of operation and/or binding.
d. If no adjustments were made, proceed to step 13.
13.
Aline and install rigid connecting link assembly (8) between manual control lever (25) and manual control lever
(15). Secure in place by installing two straight shouldered pins (7) and cotter pins (6).
14.
Operate rigid connecting link assembly (8) and check for full range of operation and binding.
a. Check that each of manual control levers (25 and 15) moves ball in each ball valve (26) from full open to full close
positions.
b. If adjustment is required, loosen jam nut (31) on each end of rigid connecting link assembly (8) and rotate steering
tie rod (32) either clockwise to shorten or counterclockwise to lengthen, as necessary.
c. If adjustment was made, tighten jam nut (31) on both ends of steering tie rod assembly (8). Repeat step 14 and
check for full range of operation and/or binding.
d. If no adjustments were made, proceed to step 15.
15.
Pass manual control lever (3) through hydraulic control module and secure manual control lever (3) to manual
control lever (15) using straight shouldered pin (5) and cotter pin (4).
16.
Aline clamp (2) over manual control lever (3) and secure by installing two bolts (1).
4-417