TM 9-2330-381-14
3.
Install rubber seal (37), washer (38), knob (36), and setscrew (35).
4.
Install rectifier (19), screw (34), washer (33), lockwasher (32), and nut (31) onto housing (6).
5.
Install regulator (20), two screws (30), washers (29), lockwashers (28), and nuts (27) onto housing (6).
6.
Install bulkhead cable clamp (26), with APU cable assembly (18) attached, onto housing (6) and secure with nut
(25). Install clamp half (24) and two screws (23) onto cable clamp (26).
7.
Connect APU cable assembly (18) to rotary switch (21) and glow plug indicator (22), if applicable.
8.
Connect APU cable assembly (18) to rectifier (19) and regulator (20).
8.1
Refer to paragraph 4-29 and install indicator light(s).
8.2
If applicable, install glow plug timer (46) and secure using screw (45), washer (44), lockwasher (43), and nut (42).
8.3
Refer to paragraph 4-32 and install control box jumper wires and timer harness.
9.
Install push-pull throttle control assembly (10) as follows:
a. Unscrew knurled nut (17) on control assembly (10) until threaded end of control assembly is accessible.
b. Insert control assembly (10) through mounting hole on plate (9) and adjust jam nut (15) until distance between
edge of jam nut (15) and end of control assembly.(10) shaft measures between 0.31 - 0.38 inch (7.8 - 9.5
mm).
c.
Install housing lock (13) and nut (12) from rear of panel (9) to secure front portion of control assembly (10).
d. Screw knurled nut (17) back onto control assembly (10).
e. Pass back portion of control assembly (10) with throttle cable (16) through housing (6) and connect to front
portion of control assembly (10) at ball and swivel. Secure connection by tightening nut (11) on control
assembly (10).
10.
Install plate (9) onto housing (6) and secure with four lockwashers (8) and thread-cutting screws (7).
11.
Install cover (2) onto housing (6) and secure with two screws (5), lockwashers (4), and nuts (3). Lift clamp
assembly (1) and close cover (2).
Change 1 4-509
