TM 9-2330-381-14
4-110. RADIATOR (CONT)
2.
Apply sealant to both surfaces of gasket (17) and install gasket, radiator base plate (16), six washers (15), bolts
3.
Apply sealant to both surfaces of gasket (12) and install gasket, radiator (1), retaining strap (9), and four bolts
(11).
4.
Install retaining strap (9), three lockwashers (8), and three nuts (7) onto three studs (10).
5.
Install shroud (6) and tighten two captive thumbscrews (5).
6.
Close drain cock (3) and replace radiator cap (2).
FLUID FILL
1.
Remove radiator cap (2).
2.
Fill radiator (1) with 1.3 quarts (1.2 1) of 70/30 mixture (70 percent antifreeze and 30 percent water).
3.
Install radiator cap (2).
4-111. FAN BELT
This task covers:
a. Removal
b. Adjustment
c. Installation
INITIAL SETUP
Tools
General mechanics tool kit, item 16, appx. B
Personnel Required:
2
Equipment Condition
APU wiring harness disconnected from fan dynamo (para. 4-39)
REMOVAL
1.
Remove two bolts (1) and fan cover (2) from fan dynamo (3).
4-516