TM 9-2330-381-14
5-13.
ULTRA BUSHING (CONT)
6.
Fit puller (9) into place over end of ultra bushing housing (10) on same side as brake chamber. Insert shaft (11),
short threaded end first, through ultra bushing housing (10) and ultra bushing (12) from side opposite brake
chamber, and thread into puller (9). Tighten puller (9) onto shaft (11) until puller (9) bottoms out. At least one full
thread should be showing.
7.
Fit cannister (13) over shaft (11) onto ultra bushing housing (10) on side opposite brake chamber.
5-34