TM 9-2330-381-14
WARNING
Residual pressure may remain in hydraulic lines. Open fittings slowly and use
caution when disconnecting power source from hydraulic ram or injury to
personnel may result.
13.
Disconnect hydraulic power source from hydraulic ram (14).
14.
Remove adjuster (15), hydraulic ram (14), and cannister (13) from shaft (11). Remove puller (9) from shaft (11).
Remove ultra bushing (12) from cannister (13).
INSPECTION
Check axle bore and ultra bushing exterior and interior for grooves, scratches, corrosion, cracks, or unusual wear. If
necessary, use a fine grade of crocus cloth to polish and restore surface finish. Replace ultra bushing as necessary.
5-37