TM 9-2330-381-14
5-16. CONNECTING LINK (CONT)
REMOVAL
1.
On steering connecting link, use an arbor press to press two sleeve bearings (1) from connecting link rod ends
(2).
2.
On nonsteering connecting link, remove two setscrews (3) and use an arbor press to press two plain bearings (4)
from connecting rod ends (5).
INSTALLATION
1.
On nonsteering connecting rods, apply antiseize compound to two plain bearings (4) and use an arbor press to
install in connecting link rod ends (5).
2.
Apply thread locking compound to two setscrews (3) and install setscrews (3) into connecting link rod end (5).
NOTE
The sleeve bearings are not symmetrical. One side has more urethane material
protruding from the steel sleeve. Ensure that the side with more material is
pointed down when installed.
3.
On steering connecting rods, use an arbor press to install two sleeve bearings (1) into connection link rod ends
(2).
5-52 Change 1
