TM 9-2330-381-14
4.
If straight pins (5) are near bottom of retainer plate (2), drive pins (5) upward approximately 0.25 inch (6.35 mm)
into mainbeam weldment (6).
NOTE
It is necessary to pry evenly both the front and back of retainer plate down onto
the steering plate spacer so that the retainer plate can be lowered clear of the pins.
5.
Using two people and a crowbar, pry down on front of retainer plate (2); then, pry down and back until retainer
plate moves down on steering plate spacer (1) and is clear of two straight pins (5).
6.
Drive and rotate retainer plate (2) 90 degrees clockwise, facing streetside.
7.
Using two people and a crowbar, pry up and remove retainer plate (2) from steering plate spacer (1).
8.
Loosen two bolts (7) on each of the service covers (8) and (9) and slide retainers (10) inboard to release and
remove service covers from platform.
Change 1 5-55