TM 9-2330-381-14
5.
Using softfaced hammer, drive shouldered shaft (7) into upper and lower suspension arms (5 and 1).
6.
Install two access covers (4), hex head screw (3), and locknut (2) to upper and lower suspension arms (5 and 1).
NOTE
Cylinder may have to be compressed using hydraulic jack to allow pin installation.
7.
Aline and install suspension cylinder lower cylinder mounting pin to lower suspension arm (1) (para. 4-41).
8.
Remove chain or strap and wood block. Leave hydraulic jack in place.
9.
Using hydraulic jack, adjust height of spindle to measurement previously recorded.
FOLLOW-ON MAINTENANCE
1.
Install axle (para. 5-12).
2.
Perform required lubrication to suspension assembly (para. 3-3).
5-16. CONNECTING LINK
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
General mechanics tool kit, item 16, appx. B
Arbor press, item 14, appx. B
Materials/Parts
Antiseize compound, item 3, appx. E
Thread locking compound, item 21, appx. E
Equipment Condition
Connecting link removed (para. 4-52)
5-51
