TM 9-2330-381-14
14.
Aline and install rod end connector (12) into straight shouldered pin (13) and, using a softfaced hammer, drive
straight shouldered pin (13) through top of steering gear arm (15) and into slide shaft assembly (16).
15.
Secure rod end connector (12) with screw (10) and lockwasher (11).
16.
Install lubrication fitting (14) into straight shouldered pin (13).
17.
Remove two lifting straps (2) and davit (1) from steering column housing (3). Restow davit (1).
18.
Install three spring pins (9) to gooseneck.
19.
Apply antiseize compound to exterior of sleeve bushing (8) and, using a softfaced hammer, drive sleeve bushing
(8) into mending plate (6).
20.
Install lubrication fitting (7) into mending plate (6).
21.
Aline mending plate (6) over steering column housing (3) and three spring pins (9). Using two people, lower
mending plate (6) onto three spring pins (9) and steering column housing (3).
22.
Secure mending plate (6) to gooseneck by installing eight lockwashers (5) and capscrews (4).
Change 1 5-77
