TM 9-2330-384-14&P
4-25. SIDE CLEARANCE AND MARKER LIGHT MAINTENANCE (Con"t).
(6)
Remove two screws (4), side clearance and marker light (3), and elbow (11) from framerail
(10).
(7)
Loosen grommet (5) and pull black wire (9) through.
(8)
Cut black wire (9) from button contact (8). Discard button contact.
(9)
Install new button contact (8) to end of black wire (9) and crimp.
(10) Thread black wire (9) through elbow (11) and side clearance and marker light (3). Install
grommet (5) through black wire. Seat grommet in neck of housing.
(11) Install lamp (7).
(12) Install elbow (11) and side clearance and marker light (3) through hole in framerail (10) with
two screws (4).
(13) Thread black wire (9) through conduit (1). Connect conduit to elbow (11) and tighten nut
(12).
(14) Thread black wire (9) into condulet (14). Connect conduit (1) to condulet and tighten nut
(13).
(15) Connect black wire (9) to two black wires (17) with new connector (18). Crimp connector.
(16) Install new gasket to cover (15). Install cover on condulet (14) and tighten two screws (16).
(17) Apply a thin coat of corrosion preventive compound to sealing lip of lens (6). Install lens.
b. REMOVAL
WARNING
When performing electrical maintenance, ALWAYS disconnect inter-
vehicular electrical cable from semitrailer. Failure to follow this warning
may create a spark and explosion, resulting in serious injury or death to
personnel.
(1)
Loosen two screws (16) and remove cover (15) from condulet (14). Remove gasket from
cover and discard.
NOTE
On roadside, black wire (9) from side clearance and marker light (3) con-
nects to two black wires (17). On curbside, black wire connects to two
brown wires.
(2)
Cut connector (18) at black wire (9) and two black wires (17). Discard connector.
(3)
Loosen nuts (12 and 13) and disconnect conduit (1) from elbow (11) and condulet (14).
(4)
Straighten conduit (1), pull from black wire (9), and remove.
(5)
Remove two screws (4), side clearance and marker light (3), and elbow (11) from framerail
(10).
(6)
Remove elbow (11) from side clearance and marker light (3). If damaged, remove gasket (2)
and discard.
4-71
