TM 9-2330-384-14&P
4-26. REAR SIDE CLEARANCE AND MARKER LIGHT MAINTENANCE.
a.
Button Contact Repair
C.
Installation
b.
Removal
Equipment Conditions:
Materials/Parts:
Conditions
Ref
One button contact
One connector
Intervehicular electrical cable discon-
Corrosion preventive compound (Item 7,
nected from semitrailer.
Tools:
Tag marker
(Item 21, Appendix E)
Tool kit, general mechanic's
General Safety Instructions:
Wire terminal kit
When performing electrical maintenance,
l
ALWAYS disconnect inter-vehicular electri-
cal cable from semitrailer.
a. BUTTON CONTACT REPAIR
WARNING
When performing electrical maintenance, ALWAYS disconnect inter-
vehicular electrical cable from semitrailer. Failure to follow this warning
may create a spark and explosion, resulting in serious injury or death to
personnel.
CAUTION
Use caution not to damage lens (9).
Carefully use a screwdriver to lift lens (9) and remove. Remove lamp (8).
(1)
Remove four screws (1) and pull stop/taillight (2) away from light box (3) enough to gain
(2)
access to wiring inside light box.
Remove four screws (6) and rear side clearance and marker light (5) from light box (3).
(3)
Loosen two grommets (11) from rear side clearance and marker light (5), and pull black wire
(4)
(10) through.
Cut black wire (10) from button contact (7). Discard button contact.
(5)
Install new button contact (7) to end of black wire (10). Crimp button contact.
(6)
Install two grommets (11) through black wire (10), Thread black wire through rear side clear-
(7)
ance and marker light (5), and seat grommets in neck of housing.
4-74
