TM 9-2330-384-14&P
4-32. BENT AXLE CHECK (Con't).
(4)
Use tape measure to measure distance between crosshatch marks (3). Record measure-
ment.
(5)
Turn wheels halfway around so that both crosshatch marks (3) are positioned at rear, Make
sure both crosshatch marks are equal height from ground. Measure distance between cross-
hatch marks. Record measurement.
(6)
If difference between front and rear measurements is more than 1/4 in. (6.4 mm), axle (2) is
bent.
(7)
Determine average side measurement for front and rear by adding both measurements and
dividing by two. Record result.
NOTE
Ensure that tape measure is straight and passes through jackstands without
(8)
Turn wheels so that crosshatch marks (3) are at bottom. Measure distance between cross-
hatch marks. Record measurement.
(9)
If difference between average side measurement recorded in step 7 and bottom measure-
ment is more than 1/4 in. (6.4 mm), axle (2) is bent.
(10) If a bent axle (2) is found with this procedure, notify direct support maintenance to replace
axle.
FOLLOW-ON TASKS:
l
Remove jackstands and lower axle.
l
l
4-96