TM 9-2330-384-14&P
4-76.
EMERGENCY VALVE AND VAPOR VENT CABLES AND TUBING MAINTENANCE
(Con't).
c. INSTALLATION OF CABLE AND TUBING
NOTE
This procedure describes installation of an entire cable (11) and tubing
l
(5) assembly.
To connect cable (11) and tubing (5) at emergency valve (6), refer to
l
subparagraph e.
To connect cable (11) and tubing (5) at vapor vent (3), refer to subpara-
l
graph g.
To connect cable (11) and tubing (5) at cabinet (7), refer to paragraph
l
To connect cable (11) and tubing (5) at remote trip-release (1), refer to
l
(1) Working from cabinet (7) end,
bend new length of tubing (5),
using old tubing as a guide. To
ensure smooth operation of cable
(11) inside tubing, do not kink or
deform any bends.
(2)
Apply grease to all grommets (8) to allow for easier installation of tubing (5).
CAUTION
Use caution when securing tubing (5) under clips (2). Improper handling
l
of clips will cause them to break.
If two or more consecutive clips (2) are missing or damaged, tubing (5)
l
will not be adequately supported.
(3)
Install new length of tubing (5) through grommets (8) and secure under clips (2) by tapping
gently on clips with a soft-faced hammer. If two or more consecutive clips are missing or
damaged, notify direct support maintenance.
(4) Connect tubing (5) at cabinet (7) end.
4-248