TM 9-2330-384-14&P
5-1. AXLE ASSEMBLY REPLACEMENT (Con't).
a. REMOVAL OF AXLE ASSEMBLY
NOTE
Front and rear axle assemblies (6) are removed the same.
Place a floor jack under middle of affected axle assembly (6). Raise axle assembly and
(1)
remove all tires (see paragraph 4-45).
Remove four nuts (8), washers (7), and two U-bolts (3) from each end of axle assembly (6).
(2)
WARNING
Axle assembly (6) is heavy and awkward to handle. Use caution, provide
adequate support, and use assistance during removal. Failure to follow this
warning may result in serious injury to personnel.
Lower axle assembly (6) on floor jack and remove from under semitrailer.
(3)
b. REMOVAL OF AXLE-MOUNTED COMPONENTS
WARNING
Axle assembly (6) is heavy and awkward to handle. Use caution, provide
adequate support, and use assistance when raising. Failure to follow this
warning may result in serious injury to personnel.
Raise axle assembly (6) on floor jack and support with suitable jackstands. Remove floor jack.
(1)
Remove wheel and drum assemblies, wheel bearings, and oil seals (see paragraphs 4-46).
(2)
5-2
