TM 9-2330-384-14&P
5-3. BRAKE SHOE REPAIR (Con't).
c. INSTALLATION OF BRAKE SHOE LININGS
NOTE
Keep hands clean when handling brake linings.
DO NOT confuse brake lining cam (2) with brake lining anchor (1). Brake
l
lining anchor has smaller cross-section and is tapered.
(1)
Clamp brake lining anchor (1) and brake lining cam (2) to brake shoe table (4) with rivet holes
alined. Locate C-clamps as close as possible to rivet holes.
(2)
Starting at center and working toward ends, drive new rivets (3) squarely into holes.
(3)
Use a feeler gage to check brake lining cam (2) and brake lining anchor (1) to brake shoe
table (4) clearance. No more than a 0.006 in. (0.15 mm) feeler gage can fit between lining
and brake shoe table (4) along edges.
FOLLOW-ON TASKS:
5-9