TM 9-2330-386-14&P
4-4 CLEANING INSTRUCTIONS (CONT) .
WARNING
d. B r a k e S h o e s .
s h o e s . There may be asbestos dust on brake shoes which
can be dangerous to your health if you breath it. Brake
shoe must be wet, and a soft bristle brush must be used.
R i n s e and allow t o d r y .
e. B e a r i n g s .
Refer to TM 9 - 2 1 4 f o r i n s t r u c t i o n s a n d p r o c e d u r e s c o v e r i n g c a r e a n d
4-5 INSPECTION INSTRUCTIONS.
a. General. All components and parts must be carefully checked to determine if
they are serviceable for reuse, if they can be repaired, or if they must be
scrapped.
b. Drilled and Trapped (Threaded) HOLES.
(1) Inspect for wear, distortion (stretching), cracks, or any other damage in
or around holes.
(2) Inspect threaded areas for wear, distortion, or evidence of cross-
threading.
(3) Mark all damaged areas for repair or replacement.
c.Flexible
Lines
(Hose)Fitting
.
(1) Inspect flexible lines for fraying, evidence of leakage, or loose metal
fittings or connectors.
(2) Check all metal fittings and connectors for thread damage. Check for hex
heads that are worn or rounded by poorly fitting wrenches.
(3) Mark all damaged material for repair or replacement.
C a s t i n g s , Forgings, and Machined
Metal Parts.
d.
(1) Inspect machined surfaces for nicks, burrs, raised metal, wear, or any
o t h e r damage.
(2) Check all inner and outer surfaces for breaks and cracks.
(3) Mark all damaged material for repair or replacement.
Refer to TM 9-214 for inspection instructions and defect analysis.
.
e.
Check for leaking fittings and
f. A i r L i n e F i t t i n g s , a n d C o n n e c t i o n s ,
connections by coating fittings and connections with soap solution. No leakage is
permissible.
4-4