TM 9-2330-386-14&P
4-24 24-VOLT RECEPTACLE (CONT) .
(2) Remove three nuts (3), lock washers (4), and ground wires (5) from
capscrews (10).
(3) Disconnect three receptacle harness connectors (6) from main wiring
harness and three harness connectors (7) from the resistors (8).
(4) Remove nut (9) from receptacle harness (12).
(5) Remove four capscrews (10) and cover (11).
( 6 ) Remove receptacle harness ( 1 2 ) f r o m n o s e p l a t e ( 2 ) .
b.
Repair.
( 1 ) A p p l y i n s u l a t i n g c o m p o u n d t o harness
wires (17) behind bushing ( 1 4 ) . S l i d e
bushing (14) along harness wires (17)
away from receptacle (15).
(2) Using pin remover tool from electrical
connector tool kit, pull pins (13) from
back of receptacle (15).
( 3 ) Using soldering gun, heat solder end of pin
and remove pins (13) from wire ends (16).
(4) Slide bushing (14) from harness wires (17).
4-40