TM 9-2330-386-14&P
4-23 12-VOLT RECEPTACLE (NOSE PLATE) (CONT).
(2) Slide boot (3) up wiring harness (4) until clear of screws (5).
(3) Loosen, but do not remove six screws (5).
(4) Withdraw six wire leads (6) from receptacle (10).
(5) Slide boot (3) off wiring harness (4).
(6) Remove two nuts (7) and lock washers (8).
(7) Remove two bolts (9) and receptacle (10).
b.Installation.
(1) position receptacle (10) on nose plate (2).
( 9 ) , lock washers (8), and nuts (7) and tighten.
(2)
Install
two
bolts
(3) Slide boot (3) on wiring harness (4), small end first.
leads (6) l/4-inch from end.
necessary, strip insulation from wire
(4)
If
4-37
