TM 9-2330-386-14&P
4-35 BRAKE CAMSHAFT (CONT).
(10) Using suitable puller, remove seal (15). Discard seal.
(11) Using hammer and suitable driver, drive outer bushing (16) from spider
(18). Discard outer bushing.
b.Installation.
(1) Position new outer
bushing (16) on brake side of spider (18), with bushing
slot centered on
location of lubrication fitting (14) hole. Tap outer
bushing (16) into
spider (18) until flush with spider surface. Hole for
lubrication fitting
(14) must be visible through slot in outer bushing
(16).
(2) Position new seal (15) in spider
(18), with seal lip (19) away from
S - c a m (20). Tap seal (15) into
spider (18) until flush with spider
surface.
(3)
Install lubrication
fitting
(14)
in
spider (18).
( 4 ) Apply clean GAA grease to bushings
( 6 , 11, and 16), camshaft (10)
journals, and seal (15) lip.
(5)
Install washer (13), 0-ring (12),
and inner bushing (11) on camshaft
(10) and slide against S-cam.
(6) Install camshaft (10) halfway through outer bushing (16) and install
washer (9).
(7) Install camshaft (10) through hole in bracket (17) while guiding inner
bushing (11) into outer bushing (16).
(10). Slide these parts into position at bracket (17).
(9) position retainer (4) with hole for lubrication fitting (2) away from
axle.
(10) Install four screws (3). Torque screws (3) to 25-40 lb-ft.
(11) Install lubrication fitting (2) in retainer (4).
(12) Slide washer (9) against seal (15).
4-67