TM9-2330-386-14&P
5-5 AXLES (CONT).
e.Axle Alinement.
T o aline the new axle with the
(1)
e x i s t i n g axle, measure between
t h e front and rear axle hub cap
plugs on both sides (A and B).
T h e measurement on both sides
should be 50-1/2 + 1/8 inch.
If the measurements are not
(2)
correct, adjust alinement plate
on axle being replaced until
measurements are within limits.
Tighten U-bolt lock nuts (4)
(3)
and end cap lock nuts (1) on
axle being replaced.
R e c h e c k the alinement of the
(4)
front axle with the rear axle.
WARNING
W e a r welding mask, gloves, and apron when welding or
using cutting torch. Failure to wear adequate protective
clothing may result in serious injury.
CAUTION
Do not attach welding ground clamps to U-bolts, springs,
o r axles except at designated weld points. These parts
should be protected from weld spatter.
W e l d the unwelded alinement plate to the spring seat to match the
(5)
prewelded plate. Welds shall be per Class 2, MIL-STD-1261.
Torque U-bolt lock nuts (4) on
(6)
to 300 lb-ft.
Torque end cap lock nuts (1) on
(7)
to 180 lb-ft.
(8)
R e m o v e axle and frame supports.
(9)
TASK ENDS HERE
5-6