TM 9-2330-386-14&P
Section III. BRAKE MAINTENANCE
5-6 BRAKE LININGS.
This task covers removal and installation.
INITIAL SETUP
Equipment Condition
Tools
References
General mechanics tool kit
Riveting tool
a. R e m o v a l .
(1) Remove 14 rivets (1) from each lining (2 and 3).
(2) Strip linings (2 and 3) from brake shoe (4).
b. I n s t a l l a t i o n .
(1) Make sure linings (2 and 3) and shoe
(4) contact faces are clean.
(2) Install new lining (3) on brake shoe
(4) with rivet holes alined.
(3) Clamp lining (3) in place and install
the first four rivets (1) in the
sequence shown.
(4) Remove clamp and continue installing
rivets (1) following the sequence
shown.
(5) Repeat steps (1) through (4) above
for remaining lining (2).
(6) Check contact of linings (2 and 3)
w i t h brake shoe (4). A 0.010 inch
f e e l e r gage should not enter between
t h e brake shoe and lining at any
p o i n t , except between the webs (5)
where a 0.025 inch gap is acceptable.
TASK ENDS HERE
5-7