TM 9-2330-388-14
SECTION X. MAINTENANCE OF CHARGING CIRCUIT
4-23.
Water Dispensing Unit Engine Electrical
4-24.
Voltage Regulator Removal and Installation
Components
a.
Voltage Regulator Removal
The following are the principle components of the engine
1.
Disconnect all wires at voltage regulator.
electrical system:
2.
Remove two Allen screws and voltage regulator.
Starting Motor: A 12-volt 1.1 KW starting motor is
mounted to the engine block.
b.
Voltage Regulator Installation
2.
Connect all wires at voltage regulator except red
amps at 3000 rpm. It utilizes a magnetized rotor and
stator-to-regulator wire at upper part of regulator.
fixed stator located beneath the engine flywheel.
Voltage Regulator: Electronic, controlled diode type, with
CAUTION
charge warning light connection.
Do not connect red stator-to-regulator wire
Battery: a 12-volt battery rated at 60/80 ampere-hours is
until after battery has been connected to
used.
engine.
4-85