Custom Search
|
|
|
||
TM 9-2330-394-13&P
BRAKE SYSTEM TROUBLESHOOTING - Continued
0037 00
BRAKE SYSTEM - Continued
Table 1. Brake System Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
6. ANTI-LOCK BRAKING
4.
If continuity is not present,
SYSTEM (ABS) DIAGNOSTIC
replace ABS control to
TOOL DOES NOT OPERATE -
diagnostic cable (WP 0072
CONTINUED
1.
Set digital multimeter to
3.
Check to see if continuity is
ohms.
present between ABS
diagnostic test connector pin
C and ABS ECU DIAGN
connector pin 3.
2.
Connect positive (+) probe
of digital multimeter to ABS
diagnostic test connector pin
C.
3.
Connect negative (-) probe
of digital multimeter to ABS
ECU DIAGN connector pin 3
and note reading on digital
multimeter.
4.
If continuity is not present,
replace ABS control to
diagnostic cable (WP 0072
0037 00-29
|
||