TM 9-2350-222-10-3
TROUBLESHOOTING - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
13. TURRET DOES NOT TRAVERSE SMOOTHLY IN POWER, OR DOES NOT
OPERATE IN POWER - Continued
Step 3. Check deck clearance switch (A) located on turret ceiling.
CAUTION
Do not attempt to adjust deck clearance
switch. An improperly adjusted switch can al-
low the gun to depress too far and may dam-
age the vehicle.
a. If switch is disconnected, connect.
b. If connectors are connected, notify organizational maintenance.
Step 4. Check hydraulic fluid level (page 3-254).
If fluid is low, add fluid and turn on ELEV/TRAV POWER switch.
Step 5. Listen for operation of electric motor below accumulator. If electric
motor runs longer than 15 seconds, make sure BATT GEN
INDICATOR (driver's master panel ) pointer is in green with
engine running.
a. If pointer is in yellow or left red, see symptom 7 (page 3-20).
b. If pointer is in right red, see symptom 8 (page 3-21 ).
c. If BATT GEN INDICATOR pointer is in green with engine
running, notify organizational maintenance of hydraulic power
pack problem.
NOTE
If required, continue to operate with manual
traverse after turning off turret power.
Change 4
