TM 9-2350-222-10-3
REPLACE INTERIOR LAMPS (REPLACE HYDRAULIC PANEL LAMP) - Continued
5. Aline pins (G) of good lamp (E)
with socket (D).
6. Push good lamp (E) into socket
(D). Rotate clockwise to tighten.
7. Place lens cap (C) in socket (D).
Turn clockwise to tighten.
To Test HYDRAULIC PUMP Indicator After Lamp Replacement: .
1.
Set MASTER BATTERY switch
(A) to ON.
2.
Set HYDRAULIC PUMP switch
(B) to ON. Indicator should light.
3.
Set HYDRAULIC PUMP switch
(B) to OFF.
4.
Set MASTER BATTERY switch
(A) to OFF.
5.
If indicator failed to light, notify
organizational maintenance.
TA133149
3-319
