TM 9-2350-277-10
ASSEMBLY AND PREPARATION FOR USE MORTAR FIRE CONTROL
0086 01
SYSTEM (MFCS), M95 ONLY -- Continued
1.
Obtain CI, GD, PD, PLGR/DAGR, and DD from secured place in accordance with unit standard operating procedure
(SOP). If necessary, remove dust protective cap and connect keyboard cable (13) on computer (10).
NOTE
Steps 2 - 8 apply to installation of commander's interface (CI).
2.
Ensure that computer mounting bracket (5) is secured to ram mount (2). Align two guide pins (11) of computer (10) with
holes in two guide pin receptacles (12) of computer mounting bracket. Install computer on computer mounting bracket.
3.
Align two retainer assemblies (4) with two locking fixtures (3) on computer (10). Tighten to secure computer.
4.
Open spring snap on safety lanyard (1) and install in center hole of computer mounting bracket (5).
5.
Align key on cable connector (15) with keyway in J1 connector (14). Install power/data cable connector to J1 connector
on computer (10). Ensure that cable is in non-binding position.
6.
Release rubber fastener (6) on each side of computer (10) and pull keyboard down and away from computer display area.
7.
Place spring-loaded latch (8) on arm assembly (7) to secure keyboard at desired position.
8.
If computer (10) is installed in the vehicle during travel, release spring-loaded latch (8) and fold keyboard against display
area. Pull two rubber fasteners (6) into two U-shaped extensions (9) to secure keyboard. Position computer to avoid
interference with commander's activities and to avoid contact with other interior items. Hand tighten ram mount (2).
0086 01-2
Change 4
