TM 9-2350-277-10
BREAK/JOIN T130 TRACK -- Continued
0092 00
WARNING
Always wear eye protection when using a hammer. Eye injury may result if metal chips
contact eyes.
Tighten each track fixture an equal amount to line up track pin holes. Tap long end of drive pin punch through track pin
4.
holes to other side of track. Wear industrial goggles and use hammer. Tighten track fixture as needed to obtain 20 degree
angle between shoes to be connected. Use adjustable wrench.
WARNING
Track shoe bushing failure can cause track assembly failure and loss of vehicle control. Soldiers
can be killed or injured.
Do not use excessive force that could damage the track shoe bushing while driving in the track
pin during assembly.
5.
From inside of track, install track pin in track pin hole. As helper aligns track pin holes with crowbar, lightly tap in track
pin. Drive track pin all the way through track. Wear industrial goggles and use hammer.
0092 00-7
Change 4
