TM 9-2350-277-10
BREAK/JOIN T150 TRACK
THIS WORK PACKAGE COVERS:
Break Track (page 0092 01-1).
Join Track (page 0092 01-6).
INITIAL SETUP:
Personnel Required
Maintenance Level
Driver
Operator
Crew
Tools and Special Tools
References
Crowbar (WP 0102 00, Table 2, Item 13)
End Connector Remover (WP 0102 00, Table
2, Item 44A)
Grease Gun (WP 0102 00, Table 2, Item 25)
Hammer, 2 lb (WP 0102 00, Table 2, Item 26) or
Hammer, 4 lb (WP 0103 00)
Adjustable Wrench (WP 0102 00, Table 2, Item 64)
Equipment Condition
Handle, Socket Wrench, 3/4 inch drive (WP 0102 00,
Engine stopped (WP 0024 00)
Table 2, Item 30A)
Extension Wrench (WP 0102 00, Table 2 , Item 19A)
Socket, 1 1/8 inch, 3/4 inch drive (WP 0102 00, Table
2, Item 49A)
Track Fixture (2) (WP 0102 00, Table 2, Item 23)
Tool, Track Pin Alignment (2) (WP 0102 00, Table
2, Item 59A)
Industrial Goggles (WP 0103 00)
BREAK TRACK
1.
Unstow crowbar and track fixtures from rear top of deck. Remove industrial goggles and hammer from tool bag.
2.
Start engine (WP 0021 00).
3.
Drive carrier to firm level ground (WP 0023 00).
Change 4
