TM 9-2350-277-10
BREAK/JOIN T130 TRACK -- Continued
0092 00
6.
Install a nut on the other end of the track pin. Tighten both nuts until two or three threads show between the nuts and the
ends of the pin or about 1/8 of an inch. Use 1/2 inch drive socket handle and 11/16 inch socket.
7.
Mark nut so unit maintenance can torque it.
8.
Remove two track fixtures. Use adjustable wrench.
9.
10. Stow crowbar and track fixtures on rear top deck. Stow hammer and industrial goggles in tool bag.
12. Fill out DA Form 2404 to notify unit maintenance to torque marked track pin nut.
END OF TASK
0092 00-8
Change 4