TM 9-2350-277-10
SERVICE BILGE PUMPS -- Continued
0096 00
10. Position bilge pump strainer on weld nuts and secure with two flat washers, lockwashers and screws. Use cross tip
screwdriver.
11. Connect lead to bilge pump.
12. Install front access cover on hull and secure with four washers and screws. Use 1/2 inch drive socket wrench handle and
3/4 inch socket.
13. Close power plant access door. See task: OPEN/CLOSE POWER PLANT ACCESS DOOR (WP 0011 00).
14. Stow trim vane. See task: LOWER/STOW TRIM VANE (WP 0039 00).
0096 00-4
