TM 9-2590-209-14&P
d. Disconnect six hose assemblies from
a. Install two new lugs and pads if
replacement is necessary (view D).
securing cover and gasket to manifold as-
sembly, and remove cover and gasket (view
b. Attach lifting cable to manifold
B).
assembly cover and position on front of
vehicle (view D).
securing control linkage guard and gasket.
c. Install two pins, washers, and cotter
pins securing top of manifold assembly to lugs
g. Remove pin and cotter pin securing
(view D).
clevis to control valve assembly, and push
clevis rod through bottom of manifold as-
d. Remove lifting cable from manifold
sembly housing (view B).
assembly cover (view D).
h. Install cover and secure with 12
screws and lockwashers (view B).
washers securing bottom of manifold assem-
bly to pads (view D).
i. Remove four elbows from left and
right sides of manifold assembly (view C).
f. Install four elbows to left and right
sides of manifold assembly (view C).
j. Attach lifting cable to manifold
assembly cover. Take up slack (view D).
g. Remove 12 screws and lockwashers,
and remove cover and gasket from manifold
k. Remove two screws, lockwashers,
assembly (view B).
and washers securing bottom of manifold
assembly to pads (view D).
h. Pull clevis rod through bottom of
manifold assembly housing, and secure to
l. Remove two pins, washers, and cot-
control valve assembly with pin and cotter
ter pins securing top of manifold assembly to
pin (view B).
lugs. Remove manifold assembly from vehi-
cle (view D).
securing control linkage guard and gasket.
m. Remove two lugs and pads if repair
is necessary (view D).
j. Install cover and gasket to manifold
assembly, and secure with 12 screws and
4-45. Cleaning and Inspection.
lockwashers (view B).
a. Clean all parts, including housing
k. Connect six hose assemblies to
mating surfaces, using drycleaning solvent.
manifold assembly (view A).
b. Inspect all components for cracks or
l. Install guards to left and right sides
damage.
c. Inspect machined surfaces for pit-
m. Fill and bleed hydraulic system (fig
ting or wear.
d. Inspect remaining hardware fort
wear, damaged threads, and general service-
ability. Replace components as required.
4-29