TM 9-2590-209-14&P
i. Apply lift with hoist and remove power takeoff
4-69. Assembly (Fig -21).
assembly and gasket from transmission (view B).
Remove hoist and rope.
a. Install two gaskets and ring assembly to
transmission power takeoff sprocket opening.
j. Remove four screws, lockwashers, and spacers
securing mounting bracket to side of transmission, and
b. Install two plugs in side and bottom of magnetic
remove mounting bracket (view C).
clutch housing.
c. Install two plugs in side and bottom of power
4-67. Disassembly (Fig 4-21).
takeoff assembly right-angle drive.
a. Remove six nuts, washers, and studs securing
d. Install two gaskets, plugs, and fit- tings in top
hydraulic pump assembly to mag netic clutch, and
remove pump assembly.
cover of power takeoff assembly right-angle drive and
magnetic clutch.
b. Remove eight nuts and lockwashers securing
e. Position magnetic clutch to power takeoff right-
magnetic clutch cover and gasket, remove magnetic
clutch assembly and gasket.
angle drive after installing gasket and seal. Secure with
six screws and lock washers.
c. Using a 3/8-inch socket wrench, remove screw
f. Insert spider gear into magnetic clutch housing.
and lockwasher securing spider gear to drive gear.
Disconnect spider gear from gear set of right-angle drive,
g. Using a 3/8-inch socket wrench, install screw
and remove from clutch housing.
and lockwasher securing spider gear to gear set of right-
d. Remove six screws and lockwashers securing
angle drive in clutch housing.
magnetic clutch to power takeoff right-angle drive, and
h. Position magnetic clutch assembly and gasket in
remove magnetic clutch housing seal and gasket.
housing, and secure with eight nuts and lockwashers.
e. Remove two fittings, plugs, and gaskets from
i. Position hydraulic pump assembly with gasket to
top cover of right-angle drive and magnetic clutch.
magnetic clutch, and secure with six nuts, washers, and
f. Remove two plugs from side and bottom of
studs.
right-angle drive.
I. Insert sprocket assembly on power takeoff drive
g. Remove two plugs from side and bottom of
gear.
magnetic clutch housing.
k. Install mounting bracket with two nuts and
h. Remove sprocket assembly from power takeoff
lockwashers.
opening by pulling from power takeoff drive gear.
4-70. Installation (Fig 4-20).
i. Remove two gasket and ring assemblies from
]
transmission power takeoff sprocket opening by
a. Position mounting bracket on side of
removing two screws and lockwashers.
transmission, and secure with four screws, lockwashers,
and spacers (view C).
f. Remove mounting bracket from hydraulic pump
b. Attach rope and suitable hoist (minimum
assembly by removing two washers and nuts.
capacity 250 lb)j and lift power takeoff assembly and
gasket into position on transmission (view B).
4-42
