TM 9-2590-209-14&P
f. Install two
i. Install guard to left rear fender, and secure with
hose
assemblies
to
reservoir
assembly (view D).
two bolts, lockwashers, washers, and nuts (view A).
g. Install lower guard to left rear fender, and
j. Install upper guard to lower guard and secure
secure with three screws, lock-washers, and nuts (view
with five screws and lockwashers (view A).
C).
k. Install support to upper guard, and secure with
h. Connect two seals and tubes to elbows (view
two screws and lockwashers (view A).
B).
l.
Fill hydraulic system with oil (fig 3-1).
Section XVI. MAINTENANCE OF MAGNETIC CLUTCH
assemblies to hydraulic pump assembly.
Disconnect
4-66. Description. The magnetic clutch is mounted in
hoses (view A, fig 4-20).
the vehicle as an integral part of the pump and drive
assembly. The pump and drive assembly is composed
d. Remove two screws, lockwashers, washers, and
of: (1) hydraulic pump assembly, (2) magnetic clutch,
nuts securing hydraulic pump assembly mounting
and (3) power takeoff right-angle drive.
bracket to transmission mounting bracket (view A).
CAUTION
e. Disconnect electrical lead from magnetic clutch
Do not remove drain plugs or disconnect
(view A).
tubes while engine is running to prevent
damage to hydraulic pump.
f. Attach rope and suitable hoist (minimum capacity
250 lb), and apply tension on rope to support weight of
4-67. Removal (Fig 4-20)
unit (view B).
g. Remove five screws, lockwashers, and washers
a. Disconnect lines carefully to relieve pressure.
securing power takeoff assembly unit to transmission
Drain hydraulic system (fig 4-1).
(view B).
b. Open rear grille doors and remove transmission
h.
Pull power takeoff assembly away from
shroud. See TM 9-2350-215-20 (M60, M60A1), TM 9-
transmission to disengage right-angle drive from drive
2350-257-20-1 (MB0A1 RISE), or TM 9-2350-253-20-1
sprocket in transmission (view B).
(M60A3).
c.
Remove eight screws, lockwashers, four
flanges, and two packings securing two hydraulic hose
4-41
