TM 9-2590-209-14&P
Section V. INSTALLATION OF BLADE ASSEMBLY MANUAL CONTROL LEVER AND LINKAGE
a. Install control lever in driver's compartment (view
9-8.
General. This section provides instructions for
the installation of blade assembly manual control lever
and linkage.
9-9.
Control Lever and Linkage (Interior).
NOTE
Refer to figure 9-4 for M60 vehicles
and figure 9-5 for M60A1, M60A1
RISE, and M60A3 vehicles.
Section VI. INSTALLATION OF POWER TAKEOFF, SPROCKET ASSEMBLY, HOSES AND BRACKET
g. Connect hose 8675761 to upper pump port and
9-10. General. This section provides instructions for
secure with gasket MS28775-228, two flanges 7340002,
the installation of the power takeoff, sprocket assembly
four screws MS90728-111, and lockwashers MS35338-
and bracket.
48 (view B).
9-11. Power Takeoff, Sprocket Assembly, and
h. Install gasket 7383694 and ring assembly
Bracket (Fig 9 -6)
10940666 to power takeoff, and secure with two screws
a. Open the engine exhaust access door and
MS90728-35 and lock- washers MS35338-45 (view C).
remove exhaust elbows. Refer to TM 9- 2350-215-20
i. Install four spacers 7699818 and bracket
(M60, M60A1), TM 9-2350-257- 20-1 (M6OA1 RISE), or
10940698 on transmission, and secure with two screws
TM 9-2350-253-20-1 (M60A3).
MS90727-114 and lockwasher MS35338-48 (view C).
b. Remove transmission shroud. Refer to TM 9-
j. Install gasket 7699926 on transmission opening
2350-215-20 (M60, M60A1), TM 9- 2350-257-20-1
(view C).
(M60A1 RISE), or TM 9-2350- 253-20-1 (M60A3).
k. Using ropes and lifting devices, position power
c. Remove power takeoff access cover TM 9-2520-
takeoff 10940668 to transmission opening and bracket
223-34.
10940698 so power takeoff shaft splines are aligned with
d. Install sprocket assembly 7699894 in
sprocket assembly splines (view C).
power takeoff (view A).
l. Secure power takeoff 10940668 to transmission
e. Place power takeoff on bench.
opening with five screws MS90727-92, lockwashers
f. Connect hose 8675762 to lower pump port and
MS35338-47, and washer MS27183-16 (view C).
secure with gasket MS28775- 228, two flanges 7340002,
m. Secure power takeoff 10940668 to bracket with
four screws M890728-111, and lockwashers MS35338-
two screws MS90727-115, lock- washers MS35338-48,
48 (view B).
washers MS27183-18, and nuts MS51968-14 (view C).
9-6
