TM 9-2590-209-14&P
and tightened. Weld in accordance with TM
c. Position large and small tubes at rear of tank
9-237.
and install brackets (5 places). Hold each bracket in
9-14. Access Plate and Elbows (Fig 9-5).
place with two screws and lockwashers (view B).
a. Remove two screws and lockwashers
d. Remove left brake access plate and stow in
from all left torsion bar housings (view A).
removed stowage box.
b. Install tube mounting brackets (5 places) on left
torsion bar housing and hold in place with two screws
e. Install two clamp plates, elbows, and existing
and lockwashers (view A).
gaskets to hull and hold in place with eight screws and
existing Iockwashers (view C.)
NOTE
Tighten screws on brackets after tube
f. Install pressure tube to elbow using flanges and
connections have been properly
gasket. Hold tube and elbow in place with six screws
made.
and lockwashers (view D).
Figure 9-7. Tubing and hoses-installed view.
9-11
