TM 9-2590-209-14&P
Section XII. INSTALLATION OF HEADLAMPS AND GUARDS
a. Install two supports and secure with four screws
9-31. General. This section provides instructions for
and washers.
the installation of the headlamps and guards.
b. Install headlamp guard on supports and secure
NOTE
pins.
Procedure for left side and right side
c. Install adapter and existing head-lamp assembly.
are the same.
Section XIII. INSTALLATION OF ELECTRICAL SYSTEMS
b. Position bracket in mounting location and secure
9-33. General. This section provides instructions for
with two screws, washers, and nuts (M60) or four screws
the installation of the electrical wiring harnesses and
electrical switch, indicator, and circuit breaker for the
c. Install switch to rear of bracket and secure with
M60, M60A1, M80A1 RISE, and M60A3 tanks.
two screws and lockwashers.
9-34. Switch, Indicator, and Circuit Breaker (Figs 9-22 or
d. Remove lens cap from indicator. Install indicator
a. Be sure pump switch bracket is trimmed to fit
to rear of bracket, and secure with two screws and
lockwashers; then install lens cap to indicator.
e. Install circuit breaker to rear of bracket, and
secure with two screws, nuts, and lockwashers.
9-29