REMOVAL:
INSTALLATION:
INSERT CROWBAR AND USE AS LEVER TO
INSERT CROWBAR AND APPLY LEVERAGE TO
SUPPORT WEIGHT ON INNER TILT ARM (LEFT AND
RAISE INNER TILT ARMS (LEFT AND RIGHT) TO
RIGHT).
MOUNTING POSITION ON HULL MOUNTING
BRACKETS.
REMOVE SCREWS, LOCKWASHERS, LOCKS, AND
INSTALL PINS,
LOCKS,
AND
PINS SECURING INNER TILT ARMS (LEFT AND
SCREWS.
RIGHT) TO HULL MOUNTING BRACKETS.
RELEASE LEVERAGE ON CROWBAR AND LOWER
INNER TILT ARMS TO REST ON REAR OF
MOLDBOARD.
Figure 3-39. Removal or installation of moldboard Assembly (sheet 2 of 4).
3-55
