PRELIMINARY PROCEDURE:
LOWER MOLDBOARD TO GROUND.
STOP VEHICLE ENGINE AND APPLY PARKING BRAKE.
REMOVAL:
INSTALLATION: INSTALL
COTTER
PIN
IN
RETAINING PIN.
REMOVE COTTER PIN FROM RETAINING PIN.
PLACE CARRYING HOOKS IN FORWARD POSITION
REMOVE RETAINING PIN FROM CLEVIS AND ARM.
AND ATTACH CLEVIS TO ARM WITH RETAINING
PIN.
LOOSEN NUT ON HANDLE AND UNSCREW CLEVIS
AND NUT FROM HANDLE.
DOGS ON HANDLE SHOULD FIT FREELY BEHIND
SUPPORT.
REMOVE HANDLE FROM SUPPORT.
ADJUST CLEVIS, IF NECESSARY, AND TIGHTEN
NUT.
INSERT HANDLE IN SUPPORT.
SCREW NUT AND CLEVIS ONTO HANDLE.
Figure 3-44. Removal or installation of moldboard carrying hooks and shafts (sheet 1 of 2).
3-60
