ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
4-36. High Tension Cables.
b. Test
c. Installation
a. Removal
This task covers:
INITIAL SETUP
Equipment Condition
Tools
a. Removal. (figure 4-30)
NOTE
The removal and installation procedures are the same for all high tension cables.
(1) Loosen connector nut (1) and tag and remove high tension cable (2).
(2) Loosen connector nut (3) and remove high tension cable (2).
(3) Remove grommet (4) and remove high tension cable (2) from left hand shroud (5).
b. Test.
(1) Perform continuity test between spring ends on high tension cable. If continuity is not present, replace
high tension cable.
(2) Perform continuity test between metal ends of high tension cable, if continuity is not present, replace
high tension cable.
(3) Perform continuity test between metal end of high tension cable and spring end. If continuity is present,
replace high tension cable.
c. Installation. (figure 4-30)
(1) Install grommet (4) on high tension cable (2) and install in left hand shroud (5).
(2) Install high tension cable (2) and tighten connector nut (3).
(3) Install high tension cable (2) as tagged and tighten connector nut (1).