ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
b. Installation
This task covers:
a. Removal
INITIAL SETUP
Equipment Condition
Tools
Air intake elbow removed (para. 4-21).
General Mechanic's Tool Kit (Item 1, Appendix B)
Materials/Parts
Rags, Wiping (Item 7, Appendix D)
Solvent, Drycleaning (Item 8, Appendix D)
(1) Loosen fitting nut (1).
(2) Loosen fitting nut (2) and remove governor oil tube (3).
(3) Remove two fittings (4).
WARNING
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point o f solvent is 100F.-138F. (38C.-60C.).
(4) Clean governor oil tube (3) and fittings (4) with drycleaning solvent and dry thoroughly.
(5) Inspect governor oil tube (3) and replace i f fitting nuts threads are stripped or otherwise damaged.
(6) Inspect fittings (4) and replace if damaged.
(7) Ensure there are no obstructions in governor oil tube (3).
b.
(1) Install fittings (4).
(2) Install governor oil tube (3) and finger tighten both fitting nuts (1) and (2).
(3) Tighten both fitting nuts (1) and (2) fully.
