TM 9-3418-201-14 & P.
UNIVERSAL TABLE
The hydraulic shaper is furnished with a plain table as standard equipment, however, a universal table is available
as alternate equipment when so ordered.
The universal table has a tilting top which is adjustable 15 degrees in either direction. To tilt the top loosen the
clamping nuts(l4)on both sides of the table. Unscrew and remove locating block(18);then, with the hand crank on worm
shaft(19),tilt the table to the desired position reading the angle on etched plate (22). Tighten clamping nuts (l4)before
doing any cutting.
The table also revolves on its trunnion through a complete revolution of 360 degrees. To revolve the table loosen
clamp nuts(15)and unscrew and remove tapered dowel pin (21). With a crank on worm shaft(16 or 20)the table may be
rotated to the desired angle which is read on the graduations at (l17).Tighten clamp nuts (15)before doing any cutting.
When the table is returned to the upright position dowel pin(21) may be replaced thereby assuring the exact
positioning of the table.
If the table is rotated 90 degrees to the left it will present a large flat working surface with T slots similar to a plain
table.
When raising or lowering the table do not forget to loosen the clamp nuts on the outboard table support.
10