TM 9-4110-246-14
TO 40R7-5-10-1
C.
ASSEMBLY OF EQUIPMENT.
CAUTION
Before positioning any panel, be sure camlocks are rotated fully
counterclockwise (retracted) to prevent damage to locking mechanisms .
Exercise caution when positioning panels to avoid damaging the
gaskets.
NOTE
When positioning refrigerator panels, be sure camlock sides (without
gaskets) are set up properly against mating eyelet side (with gaskets) of
the adjacent panel . Once positioned, panels are locked together by
rotating camlocks fully clockwise using hex wrench.
1.
Preparation of site: The area where refrigerator is to be erected should be level to prevent misalignment of floor
panels . For proper ventilation of underneath surface of floor panels, a completely level and structurally sound
sub-base (to support the entire refrigerator) should be built on the site from requisitioned dunnage and/or crating
lumber.
2.
Position right, center, and left floor panel assemblies, gasket sides up on prepared level surface or platform. Lock
floor panel assemblies together by rotating camlocks fully clockwise using the hex wrench.
3-4
