TM 9-4110-254-14
b. Installation.
WARNING
Coil fins are sharp and can cut hands or fingers. Wear gloves to prevent
personal injury when handling cold
(1)
Install shroud (5) onto evaporator coil (4) using ten flat washers (13), new lock washers (12),
and screws (11).
(2)
Braze three fittings (15) (para 5-9).
(3)
Install insulation (14) and secure using insulation tape as necessary.
(4)
Install evaporator coil (4) and shroud (5) into frame (10) Secure with ten screws (9)
(5)
Braze three fittings (8) (para 5-9).
(6)
Install two clamps (7) to secure heat exchanger (16).
(7)
Install insulation (6) and secure using insulation tape as necessary.
(8)
Slide fan drive shaft (3) back into place and tighten two setscrews (1) on each flange bearing (2) collar.
5-73
