TM 9-4110-254-14
5-36. COMPRESSOR B1 TESTING, REPAIR, AND REPLACEMENT.
This task covers:
a. Testing
b. Removal
c. Disassembly
d. Assembly
e. Installation
INITIAL SETUP
Materials/Parts-
Materials / Parts
Lock Washers (4)
Seal
28, Appendix G
2, Appendix G
Locknut (4)
Marker tags (15)
19, Appendix G
7, Appendix E
Service Valve Gasket (Suction)
Anti-Seize Tape
20, Appendix G
22, Appendix E
Service Valve Gasket (Discharge)
Lubricating Oil
21, Appendix G
21, Appendix E
Cylinder Head Gasket
22, Appendix G
Equipment Conditions:
Valve Plate Gasket
Front top door open
23, Appendix G
Both side doors open
Sight Glass
Top access panel removed (para 4-14)
24, Appendix G
Lock Washers (2)
General Safety Instructions.
29, Appendix G
Fused Cluster Terminal
WARNING
26, Appendix G
Fused Cluster Seal
Compressor lubricating oil used m this
27, Appendix G
refrigeration system is caustic. Wear gloves
Terminal Mounting Plate Gasket
and a face protector or safety glasses m any
4, Appendix G
situation where skin or eye contact is
Oil Pump Gasket
possible. If oil does contact skin, wash with
18, Appendix G
soap and water.
a. Service.
(1)
Check oil level through sight glass (1). If oil level is not within best operating range, discharge
refrigeration system (para 5-7).
CAUTION
Use only specified oil Compressor damage can result
NOTE
The oil fill plug cannot be purchased separately from the compressor.
Care must be taken so it does not get lost or damaged.
(2)
Remove oil fill plug (2) then add or remove lubricating oil as necessary
(3)
Wrap anti-seize tape around oil fill plug (2) threads and install oil fill plug
5-75
