TM 9-4110-255-14
4-19. WIRES, CABLES, AND HARNESSES TESTING, REPAIR, AND REPLACEMENT. - Continued
c. Removal.
(1) Tag and disconnect wire lead(s) from component.
(2) Cut tie down straps and loosen clamp(s) as necessary to remove wire(s).
(3) Remove any silicone RTV remaining in evaporator frame grommets (4).
d. Installation.
(1) Carefully route wire lead(s) through clamp(s) and grommet(s) as necessary.
(2) Connect wire lead(s) to component using tags and wiring diagram (fig. 1-4). Remove tags.
(3) Install tie down straps as necessary and tighten any clamp(s) that were loosened for removal.
(4) Apply silicone RTV into evaporator frame grommets (4) to seal evaporator enclosure.
(5) Close control panel (3). Install two new lock washers (2) and bolts (1).
NOTE
FOLLOW-ON MAINTENANCE:
Close side doors if open.
Unlatch and close control box cover.
Connect battery (para. 4-35) and put unit back into service.
4-52
